f78
nlmconv
Contents|Index|Previous|Next
nlmconv
nlmconv
converts a relocatable object file into a NetWare Loadable Module.
Warning:
nlmconv
is not always built as part of the binary utilities, since it is only useful
for NLM targets.
nlmconv [ -I bfdname | --input-target=bfdname
]
[ -O bfdname | --output-target=bfdname ]
[ -T headerfile | --header-file=headerfile ]
[ -d | --debug] [ -l linker | --linker=linker ]
[ -h | --help ] [ -V | --version ]
infile outfile
nlmconv
converts the relocatable ‘i386’
object file infile
into the NetWare Loadable Module, outfile,
optionally reading headerfile
for NLM header information.
For instructions on writing
the NLM command file language used in header files, see the section, “linkers”
or “NLMLINK” in particular, of the NLM Development and Tools Overview,
which is part of the NLM Software Developer’s Kit (“NLM SDK”),
available from Novell, Inc.
nlmconv
uses the G
ffb
NU Binary File Descriptor library to read infile;
see BFD in Using LD for more information.
nlmconv
can perform a link step. In other words, you can list more than one object
file for input if you list them in the definitions file (rather than simply
specifying one input file on the command line). In this case, nlmconv
calls the linker for you.
-I
bfdname
--input-target=bfdname
Object format of the input
file. nlmconv
can usually determine the format of a given file (so no default is necessary).
See Target Selection
for more information.
-O
bfdname
--output-target=bfdname
Object format of the output
file. nlmconv infers the output format based on the input format, e.g.,
for a ‘i386’
input file, the output format is ‘nlm32-i386’.
See Target Selection
for more information.
-T
headerfile
--header-file=headerfile
Reads headerfile
for NLM header information. For instructions on writing the NLM command
file language used in header files, see the section, “linkers” or “NLMLINK”
in particular, of the NLM Development and Tools Overview, which
is part of the NLM Software Developer’s Kit (“NLM SDK”),
available from Novell, Inc.
-d
--debug
Displays (on standard error)
the linker command line used by nlmconv.
-l
linker
--linker=linker
Use linker
for any linking. linker
can be an absolute or a relative pathname.
-h
--help
-V
--version
Prints the version number
for nlmconv.
0