ccd
E7000 in-circuit emulators
Contents|Index|Previous|Next
E7000
in-circuit emulators
You can use the E7000 in-circuit
emulator to develop code for either the Hitachi H8/300 or the H8/300H.
Use one of the following forms of the target
e7000 command
to connect gdb
to your E7000.
target e7000 port speed
Use this command if your
E7000 is connected to a serial port. The port
argument identifies what serial port to use (for example, com2).
The third argument, speed,
is the line speed in bits per second (for example, 9600).
target e7000 hostname
If your E7000 is installed
as a host on a TCP/IP network, you can just specify its hostname;
gdb
uses telnet
to connect.
The monitor command set makes
it difficult to load large amounts of data over the network without using
ftp.
We recommend you try not to issue load
commands when communicating over Ethernet; instead, use the ftpload
command.
0